AC Breaker Keeps Tripping: Is It the AC or Your Electrical?

Contents

If your AC breaker keeps tripping, do not keep resetting it. Either the AC unit is pulling too much power, or the wiring or the breaker has a problem. Reset it once at most, then work through the checks below.

A breaker is the switch in your panel that shuts a circuit off when it carries too much current. A breaker that trips is doing its job. The question is what it is warning you about.

Key Takeaways

  • Do not keep resetting an AC breaker that trips. Reset it once at most.
  • Safe first checks: thermostat off, clean the air filter, clear debris from the outdoor unit, and note when it trips.
  • When the breaker trips gives clues about whether the AC or the electrical is the cause.
  • Never swap in a bigger breaker or tape a breaker on.
  • Call an electrician for a hot breaker, buzzing or burning smell. Call an AC technician for weak air, an iced-over unit or humming.

What can I check safely before I call?

These checks are safe for most homeowners:

  • Turn the thermostat to off before you touch the breaker.
  • Check the air filter. A clogged filter makes the unit work harder.
  • Look at the outdoor unit. Clear leaves and debris from around it.
  • Reset the breaker once: push it firmly to off, then to on.
  • Write down when it trips: at start-up, after a while, or only on hot days.

Stop there. Never open the panel cover or the outdoor unit’s electrical box.

Can a tripped breaker still look like it is on?

Yes. A tripped breaker often rests in the middle position, between on and off. Push it all the way to off first, then back to on. If it sits in the middle again, the circuit still has a problem.

Is it the AC or my electrical?

The pattern gives clues. These are common patterns, not a diagnosis.

When it trips What it often points to
Right when the AC starts A short or fault in the unit or its wiring, or a failing part that draws too much power at start-up
After running for a while The unit working too hard, a dirty filter or coil, or a breaker or connection that overheats
Only on the hottest days A unit or circuit near its limit when demand is highest
It will not reset at all A fault that needs an electrician or an AC technician before you try again

In hot Calabasas summers an AC runs for hours at a time. That stresses weak wiring and aging breakers more than a short cycle does.

Illustrative example

A 14-year-old AC kept tripping its breaker. The electrician checked the circuit, the connections and the breaker rating against the unit’s nameplate, and all were fine. An AC technician then found a worn capacitor that made the compressor draw high current at start-up. After it was replaced, the unit ran normally on the same breaker.

An example of a typical job, not a specific Blue Moon customer.

How many times can a breaker trip before it goes bad?

There is no safe count. Every trip is a sign that something is wrong. Breakers can also wear out with age, but a worn breaker is a guess until someone tests it. Do not reset a breaker again and again hoping it holds.

The CPSC gives the same advice: find the cause when a breaker trips. Do not simply reset it. Make sure wiring and devices match the breaker size.

What should I never do?

Never do this

  • Never swap in a bigger breaker to stop the tripping. The wire may not handle that current.
  • Never tape or hold a breaker on.
  • Never keep running an AC that trips right after you reset it.

Do I need an electrician or an AC technician?

Call an electrician if the breaker feels hot, the panel buzzes, you smell burning, or other lights flicker. Those point to the wiring or the panel.

Call an AC technician if the air is weak, the unit ices over, or it hums but will not start. If you are not sure, call us. We can tell you which one you need.

If you smell smoke or see sparks, leave the house and call 911 first.

Next step

If your AC breaker keeps tripping, call (747) 236-6734. A licensed Blue Moon electrician can check the circuit, the breaker and the connections. Related: why lights dim when the AC turns on. See our electrician in Calabasas page for more.

Call (747) 236-6734

Source: CPSC, safety information on circuit breakers and fuses

Frequently Asked Questions

Note when it trips and what was running. Then turn off other loads and test one thing at a time. If it still trips with the AC off, the problem is in the circuit.
The circuit may have a fault, a short, or a worn breaker. Stop resetting it and call an electrician.
It can be. A repeat trip means a fault or an overload. Treat it as a warning and get it checked.
Yes. A tripped breaker often rests in the middle position between on and off. Push it all the way to off first, then back to on. If it sits in the middle again, the circuit still has a problem.
Call an electrician if the breaker feels hot, the panel buzzes, you smell burning, or other lights flicker. Call an AC technician if the air is weak, the unit ices over, or it hums but will not start. If you are not sure, call us and we can tell you which one you need.
Picture of Nino Okuashvili
Nino Okuashvili
Marketing Account Manager at Blue Moon Electrical with 8 years of experience in brand communication, coordination, and messaging across companies including Astria Learning and MA Architects.

Related Posts

Logo - Blue Moon Electrical

Is Your Electrical System Keeping Up?

Worker Main Bg - Blue Moon Electrical

Our Services

Lighting
Installation

Learn more →

Lighting
Repair

Learn more →

Outlet
Installation

Learn more →

Outlet
Repair

Learn more →

Residential
Services

Learn more →

Commercial
Services

Learn more →

Wiring
Repair

Learn more →

Wiring
Installation

Learn more →

Electrical Panel
Installation

Learn more →

Electrical Panel
Repair

Learn more →

EV Charging Station Installation

Learn more →

Smoke Detector Installation

Learn more →